batte melt pump

Rubber extrusion melt pump

Introduction of rubber extrusion melt pump The rubber melt pump is used in the elastomer and the degradable plastic extrusion system. This type of pump adopts special internal structure and has high efficient self cleaning function. It is suitable fo

The control system and accessories of the melt pump

The gear pump is installed between the extruder and the machine head, so that the fluctuation caused by the extrusion direction can be isolated from the machine head and downstream equipment. No matter whether the pressure fluctuates at the entrance

melt pump for extrusion system

Product introduction: M pulsation series is a general melt pump for extrusion system . It is mainly used for supercharging and stable flow transportation of extruder or high viscosity polymer, such as sheet, plate, pipe, film, cable, coextrusion, mix

How to maintain the melt pump daily

1. check the fasteners of the melt pump daily, such as whether the screws are loose or not, check the installation of pipeline interfaces and so on. 2. check the oil seal clean, often need to clean the oil seal, to prevent the impact of the mechanica

The cause of the release of the coupling of the melt pump coupling

The cause of the release of the coupling of the melt pump coupling 1.High load of melt pump So far, all the melt pump coupling tripping occurs when the load of the melt pump is above 110% of the design load. At the same time, compared with DuPont tec


Chat live
Fax:+86 371-67993277
Tel: +86 371-67991755
Sales direct: +86 15838331071
E-mail:sales@battemachinery.com
http://www.meltpumpextrusion.com
24h services
batte melt pump

More about screen changer products:

Spinning pumps extrusion(ZB-U)

Polymer melt pump extrusion(ZB-

Plastic melt pump extrusion(ZB-

hot melt glue pumps for sale

batte Madden chemical pump


©2019 Batte Mechanical Zhengzhou Co,.Ltd. All rights reserved. sales@battemachinery.com
Batte is a professional screen changer manufacturer, supplying screen changer, especially screen changer for extrusion mould