+86-371-67991755
Request Quote
The cause of the release of the coupling of the melt pump coupling 1.High load of melt pump So far, all the melt pump coupling tripping occurs when the load of the melt pump is above 110% of the design load. At the same time, compared with DuPont tec
Melt pump reducer This reducer mainly aims at the installation mode of linear type melt pump drive reducer . The reducer is a kind of power transmission mechanism, which uses the speed converter of gear to decelerate the number of rotation of motor (
When the centrifugal melt pump is switched, it should be done: (1) before the start of the standby melt pump , a comprehensive inspection and preparation work should be done before starting. (2) open the pump inlet valve, make the pump body full of m
The melt pump is an ideal device for the following process: Thin film profiles, wires, cables, tubes, pipes, chemical fibres, sheets and sheets, composite extrusion, nonwovens, coating, granulating, pelletizing, etc. The Batte polymer extrusion pump
The working temperature and pressure of the melt pump The working temperature generally reaches 300 degrees, which can meet the requirements of transporting most plastic melts, and the melt pump with a higher temperature can reach 500 degrees. The wo
Spinning pumps extrusion(ZB-U)
Polymer melt pump extrusion(ZB-
Plastic melt pump extrusion(ZB-
hot melt glue pumps for sale
batte Madden chemical pump